Merino Stripes Eyelet Ribbon Tam Hat
Designed and Knit by Dawn Leeseman for Crystal Palace
Yarns
Size: One size
Finished Measurements:
24” circumference, length from crown is approximately 6 ½”, covering
approximately ½ the ear.
This size sets nicely on an average size head and will stretch to
accommodate a larger head. If a closer fit is desired use one size smaller
needle.
Materials:
Crystal Palace
Merino Stripes:
1 ball - col. 030 watermelon
Optional Ribbon Trim: 1-½ yds, 7/8” silk ribbon
1 stitch marker
Tapestry needle
Crystal Palace Bamboo Needles or Daisy Needles:
Size US 10 (6mm) 16” circular and double pointed needles OR size to obtain
gauge.
Gauge:
11 sts = 4 inches and 13 rows = 4 inches, using size 10 needle in eyelet
pattern.
Be sure to make a gauge swatch before beginning project.
Abbreviations:
Beg-beginning; BO-bind off; CO-cast on; Dec-decrease; K- knit; K2tog- knit 2
stitches together; k3tog-knit 3 stitches together; Rem- remaining;
Rep-repeat; Rnds-rounds; WS-wrong side; YO-yarn over.
Knit Stitch Eyelet Tam with Ribbon:
(The eyelets slant to the right.)
Using circular needles cast on 66 stitches. To get the full effect of the
3 color changes in this yarn, start with approximately 3 yds of 1 color,
before the next color change. Place marker for beg of round; join into
round, taking care that stitches aren’t twisted.
Rnd 1: Purl
Rnd 2: Knit
Rnd 3: Purl
Rnd 4: *YO, k2tog; rep from * to end of rnd
Repeat Rnd 4 until hat measures 4 ¼”, or desired length from cast on edge.
Shape Crown:
Begin Decrease rnds as follows, changing to double pointed needles when
too few stitches to go around the circular needles.
Dec Rnd 1: *YO, k2tog, YO, k2tog, k2tog; rep from * to end of rnd. (55) sts
Even Rnd 2: *YO, k2tog, YO, k2tog, k1; rep from * to end of rnd. (55 sts; no
decrease made)
Dec Rnd 3: *YO, k2tog, YO, k3tog, rep from * to end of rnd. (44) sts
Even Rnd 4: *YO, K2tog, rep from * to end of rnd. (44 sts no decrease made)
Dec Rnd 5: *YO, k2tog, k2tog. (33) sts
Even Rnd 6: *YO, k2tog, k1, rep to end of rnd. (33 sts; no decrease made)
Dec Rnd 7: *K2tog; rep from * to last st k1. (17) sts
Dec Rnd 8: *K2tog; rep from * end k3tog. (8) sts
Leaving an 8” tail, cut yarn. Thread through tapestry needle, draw through
rem 8 sts, twice, pull tight; weave in end on WS. Weave in all rem ends,
taking care to close the gap at the joining of the first round.
Optional Ribbon tie:
Thread ribbon through tapestry needle. Leaving an 11” tail; begin
weaving in and out of the first eyelet row at bottom of cloche. Weave
loosely, keeping the ribbon untwisted so the ribbon can “puff” in each
eyelet, spread out the ribbon in each eyelet to help it “puff”. Tie a bow
with remaining tails. Trim ribbon ends on the diagonal.